Categories

Newsletter

All products

Deans Connector: Male
This is a Male Deans connector. Commonly found in RC and hobby electronics devices for power / battery lines.

$2.49
Ships Today
US to EU AC Adapter
Use our US plugged devices in countries with European plugs. Useful for overseas customers and travelling abroad.

$3.99
Ships Today
B500K Linear 500K Ohm Taper...
Use this B500K Linear Taper Pot to get a variable resistance rated to 500K Ohms when the knob is turned. Useful for Radio Transmitter repairs, guitar pedals, electric guitars etc.

$2.99
Ships Today
Slide Pot Module (Arduino...
This Dual Output Slide Potentiometer Module has 2 identical sets of 3 pins. Wire up VCC to Power, GND to 0V and the signal pin will give you a varying voltage depending on high or low you slide it.

$7.99
Ships Today
D Battery Holder with Sewable Tabs
Pop your D battery into this holder for an easy way to attach wires or sew with conductive thread to power your projects.

$0.75
Ships Today
IC Extractor Tool
Easily extract ICs from your projects using this IC Extractor Tool. Removes chips with up to 28 pins easily.

$4.25
Ships Today
Mercury Tilt Switch 6mm
Use this tilt switch to detect motion. When the switch is tilted one way, the mercury will roll down the tube and make contact between the 2 leads.

$1.95
Ships Today
Mercury Tilt Switch 5mm
Use this tilt switch to detect motion. When the switch is tilted one way, the mercury will roll down the tube and make contact between the 2 leads.

$1.89
Ships Today
Stereo Headphone Splitter 1/8"...
Split your audio easily with this 1/8" 3.5mm headphone splitter. Converts 1 Male Plug to 2 Female Jacks.

$1.75
Ships Today
CR2016 Coin Cell Battery
One CR2016 Thin Coin Cell Battery. Thinner than standard CR2032 Coin Cells but still produces 3V of power.

$1.49
Ships Today
DC-DC Boost Module
Boost your voltage from 3.3V or 5V to 12V with this assembled DC-DC Voltage Booster Module. It takes in a voltage of 2V - 6V and outputs between 5V - 16V.

$4.99
Ships Today
Optical Limit Switch / Endstop...
This Optical Limit Switch / Endstop tells your 3D printer when it has reached the end of a rail using an optical sensor instead of a mechanical switch.

$4.49
Ships Today

Christmas Ornament DIY Soldering Kit Decoration Electronic LED Red Learn to Solder: Solder together your very own light up Christmas Ornament! Add some...
Read more
Running Microbug Kit Solder DIY Robot Bug Light Sensitive: Solder & assemble this Microbug robot and watch it drive towards...
Read more
SMD Star LED Soldering Kit SMT Christmas Decoration Electronic Ornament: Solder together your very own electronic star with 20 SMD LEDs! Slowly...
Read more

» All new products

⚡ Flash Sales ⚡

Kids GPS Tracking & Phone Smart Watch
$49.90 $23.90

» All Flash Sales