Categories

Newsletter

Raspberry Pi Hats

These add-on boards are designed to fit right on top of the Raspberry Pi's GPIO pins. No wiring necessary to hook up to your pi.

« Previous
1
2
Next »

VGA666 Adapter for Raspberry Pi
Use this VGA666 Adapter to connect a VGA screen/monitor with your Raspberry Pi over the GPIO pins. Allows you to use dual display on the Raspberry Pi, VGA and HDMI at the same time! It is capable of displaying 1080p60 VGA video with no CPU load while keeping the HDMI port free.

$6.95
Ships Today
4 Port USB Hub Hat for Raspberry Pi
4 Port USB Hub Hat for Raspberry Pi. Sits on top of the GPIO pins to save space and uses 1 USB Port to convert it into 4! Adds 3 extra USB ports to your Raspberry Pi Zero, Model 4 B, etc.

$14.99
Ships Today
Raspberry Pi PoE Hat
The official Power over Ethernet (PoE) add-on board for the Raspberry Pi 3 Model B+. Use this HAT to power a Raspberry Pi via an Ethernet cable, removing the need for a separate power supply, an ideal solution for embedded and IoT projects.

$29.99
Ships Today
E-ink Display for Raspberry Pi Zero
e Ink / ePaper Display Raspberry Pi Zero Hat measuring 2.13 inches. Low power consumption and stays locked on the last loaded screen even when not powered!

$29.99
Sold Out/Backorder
Gameboy Style Gamepad Hat for...
Put this Gameboy Style Gamepad Hat on top of your Raspberry Pi to turn your Pi into a Gameboy Style Pocket Videogame player! Comes fully assembled, sits on top of the Raspberry Pi's 40 pin GPIO port.

$49.80
Ships Today
Raspberry Pi Lipo Battery Power...
Attach this Lipo Battery Power Hat on top or below your Raspberry Pi with the included standoffs to easily interface with Lipo batteries up to 3800mah. Allows you to power your Pi and one other USB item from a Lipo Battery as well as charge it. Built in charging circuit & boost circuit in a Raspberry Pi form factor!

$13.90
Ships Today
Pi PoE Switch Hat
Power your Pi and get network connectivity all through the same cable with this PoE Switch Hat for Raspberry Pi.

$41.99
Ships Today
e-Ink / e Paper Raspberry Pi Hat
e Ink / ePaper Display Raspberry Pi Hat measuring 2.7 inches. Low power consumption and stays locked on the last loaded screen even when not powered!

$38.99
Ships Today
Raspberry Pi DAC Hifi Audio Hat
Want High-Quality Audio Output for the Raspberry Pi? This Hifi Audio Card fits directly on top of your Raspberry Pi's 40 Pin GPIO pins! Save space with this Hifi DAC Hat for Raspberry Pi.

$29.99
Ships Today
Raspberry Pi Prototyping Hat 40 Pin
Pop this Prototyping Hat on top of your Raspberry Pi Zero, 2, A+ or B+ to give your circuits a super quick connect/disconnect from the Raspberry Pi. You can solder your projects directly onto the protohat and pop them on/off your Raspberry Pi without any wiring! Useful for quickly swapping out your Raspberry Pi between projects.

$16.99
Ships Today
Raspberry Pi Sense Hat
Place this Pi Sense Hat on top your Raspberry Pi to add an 8x8 RGB LED matrix, five-button joystick, gyroscope, accelerometer, magnetometer, temperature sensor, barometric pressure sensor and humidity sensor.

$39.99
Ships Today
Raspberry Pi Servo / PWM Hat -...
Control Servos and DC Motors directly from your Raspberry Pi with this Servo / PWM Hat.

$24.99
Ships Today

« Previous
1
2
Next »

MM74C89N 64-Bit 3-STATE Random Access Read/write Memory: The MM74C89 64-Bit 3-STATE Random Access Read/Write Memory is a 16-word...
Read more
DMX512 SPI Decoder - Digital RGB Addressable LED Decoder/Controller - 5-24 VDC: Control your Addressable RGB LED strips via DMX with this DMX 512...
Read more
Electronics Tool Kit - 15 Piece 80W: Electronics Tool Kit including: 80W Soldering Iron, Desoldering Pump,...
Read more
Screw Type Watch Case Wrench Back Opening Tool Adjustable for Watch Repair: Open watch backs to replace batteries and repair watches with twist on...
Read more
5 Pin Header Connector: Plastic housing that holds up to 5 male or female jumper wire crimp...
Read more
Sony Ericsson Car Charger for A1228 T28 and more OEM Model 402 0054 BV: Sony Ericsson Car Charger for A1228 T28 and more OEM Model 402 0054 BV
Read more
ESP Breakout PCB for ESP-07, ESP-08, ESP-12E: Plug your ESP directly into a breadboard with this ESP Breakout PCB....
Read more
WWVB NIST Radio Time Receiver Kit (1.2V to 5V) Pre-Soldered: Always have accurate UTC time for your projects and Atomic Clocks. Use...
Read more

» All new products

⚡ Flash Sales ⚡

Bare Conductive Touch Board
$74.99 $51.99

» All Flash Sales