High Density RGB LED Strip - Addressable 4m (NeoPixel Compatible, WS2812, Waterproof)

When you want to control each LED's color and intensity individually and A LOT of LEDs, this is your solution. Create cool lighting displays where each LED can be controlled all on it's own and turn on/off, change color and brightness by itself. Use an Arduino board to control the strip using just 2 pins just like our LED Sequins and Addressable RGB LEDs. Each LED has a chip inside it to control it's behavior on it's own which allows you to cut the strip after any single LED if you want to use a shorter length!

  Specifications:

• LED Type: 5050 SMD Pixel (Individually Addressable Neopixel Compatible)
• Chipset: WS2812 (Same as our LED Sequins and Addressable RGB LEDs)

• Size: Length 4 meters x Width 1.2cm x Thickness 0.5cm

• Emitting Color: RGB (every LED can be a different color at the same time)

• IP67 Waterproof
• Grey Scale: 256
• 8 bit color

• Working Voltage: 5V DC

• LED Quantity: 240 LEDs

• Max Wattage 18W/meter
• Max DC Current Draw: 3.6A/meter
• Viewing Angle: 120 degrees

• JST Connector Pinout:
• VCC: Red Wire, 5V
• GND: White Wire, 0V
• DIN: Green Wire, Data In
• DOUT: Data Out (Green wire, to next strip)
• Every LED is cuttable!

 Use this power supply to power the whole strip, controller also needed (sold separartely).