3 Pin RGB LED Strip Interconnector Cable Coupler with Wire 6.6 inch

After cutting your RGB LED strips to size, you can use this RGB LED Strip Interconnector Cable to attach them together without soldering. Just place one strip into the left and snap shut, then place the strip you want to connect it to in the right! Easy solderless RGB LED strip connections for easily reusing already cut pieces and for fixing accidental cuts. Perfect for lighting professionals who re-use RGB LED strips from one installation to the next!

Specifications:

• 3 Pin RGB LED Strip Interconnector Cable
• Number of contacts: 3 per side
• Connector A: RGB LED Strip Receptacle
• Connector B: RGB LED Strip Receptacle
• Pin Pitch: 2.5mm
• Snap together design to hold strip tightly in place
• Flexible 5.4 inch (13.7cm) cable for easy bending and flexing
• Overall Length: 6.6 inch (16.8cm)

• Works with:
• TS1179 RGB LED Strip - Addressable 1m (NeoPixel Compatible, WS2812)
• TS1210 High Density RGB LED Strip - Addressable 1m (NeoPixel Compatible, WS2812, Waterproof)
• TS1342 Addressable RGB LED Strip 144 Pixel - 1m (Neopixel Compatible)
• TS1178 Super Long RGB LED Strip - Addressable 5m (NeoPixel Compatible, WS2812)
  
• TS-813 Waterproof Super Long LED RGB Strip - Addressable, 5m (NeoPixel Compatible, WS2812)

• Instructions:
• Open the plastic cover clip to reveal the metal pins inside the connector
• Slide the bare LED strip under the metal contacts
• Make sure the 3 metal contacts on the LED strip are touching the coupler's metal contacts
• Close the plastic cover clip to secure in place
• Repeat on the other side