MHF4 to IPEX IPX UFL U.FL PCB Antenna Connector Splitter
Price:
$4.99
PCB / Board antenna splitter 1 to 2. IPEX Y Type Splitter Cable 1 MHF4 Plug Right Angle to 2x UFL U.FL PCB 0.81mm IPX.
Features:
- Useful for splitting uFL/u.FL/IPX/IPEX antenna connections on printed circuit boards
- Y type splitter: 1 to 2.
- Side A : 1pcs MHF4 plug right angle connector ( center hole is female pin )
- Side B : 2pcs uFL/u.FL/IPX/IPEX SMD on PCB ( center is male pin )
- Cable Type : OD 0.81mm diameter RF Pigtail Coax
- Cable Length : 2 inches ( 5cm )
- Impedance : 50 ohm
- Gold plated or Nickel plated contacts
- Salt spray test : >= 48 hours, enhanced corrosion resistance
- Mounting : machined brass construction crimp & soldered mount
- Connection Protection: Black Heat Melt Shrink Tube Versafit or equivalent
- Operating frequency :0-6 GHZ ( option: 1.2Ghz 2.4Ghz 3Ghz 6Ghz 8Ghz 12Ghz 18G... )
- Technical characteristics : temp. range : -65 to +165 ( PE cable range : -55 to +85 )
4 other products in the same category
RF Link Transmitter & Receiver Module Pair: 433MHz or 315MHz (for Arduino & Raspberry Pi)
$8.95
Rated out of 5 stars based on
review(s)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent