Categories

Newsletter

Parts & Components

Audio / Video, Cables & Wires, Breadboard & Perfboarding, 3D Printing Parts & Filaments, Arduinos, Raspberry Pis, Sensors, etc.

Infrared LED Ring Attachment for...
Add night vision to your Raspberry Pi projects with this Infrared LED ring attachment for the Raspberry Pi NoIR cameras.

$10.99
Ships Today
NE5532 Pre-Amplifier Preamp with...
Use this NE5532 Pre-Amplifier board to adjust treble, alto, bass and volume with the 4 different dials. AC 12V NE5532 Pre-Amplifier Preamp. Soldering Kit. 4 convenient dials to control treble, alto, bass and volume separately.

$14.99
Ships Today
Vacuum Tube Stereo Amplifier Kit
Put together this Stereo RCA Vacuum Tube Amplifier kit to increase the amplitude or power of a signal for Hifi applications! Soldering Kit.

$16.99
Ships Today
NE5532 Pre-Amplifier Preamp Bass...
Use this NE5532 Pre-Amplifier board to amplify mono or stereo audio. DC 12V-24V Low-pass Filter NE5532 Bass Tone Subwoofer Pre-Amplifier Preamp. Comes fully assembled. 2 convenient dials to control each channel independently.

$9.99
Ships Today
XNOR Gate: 74LS266
This chip includes 4 basic digital logic XNOR gates. Each XNOR gate takes in 2 inputs and gives out a HIGH output if input 1 OR input 2 is are the same (both HIGH or both LOW) but not one or the other.

$1.99
Ships Today
TSL2591 High Dynamic Range...
Use this Ultra High Range Light Sensor Module to get precise luminosity readings. Configurable gain/timing ranges so you can measure from 188 uLux to 88,000 Lux. Arduino and Raspberry Pi Compatible.

$6.90
Ships Today
ATSAMD21 Cortex M0 Mini Breakout...
An upgrade from 8-bit/16MHz Arduino microcontrollers, the SAMD21 Mini Breakout is a Pro Mini-sized breakout for the Atmel ATSAMD21G18, a 32-bit ARM Cortex-M0+ processor with 256KB flash, 32KB SRAM, and an operating speed of up to 48MHz. Solves the problems of low storage limits and dynamic memory stack overflows and fully supported in the Arduino IDE and...

$19.90
Ships Today
DIY Clapper Switch
Control your lights with two claps. The on board microphone picks up on loud noises (claps). When a single clap is detected, a countdown begins, and the device waits for another clap. If another clap is detected within a short period after the first clap, then the relay will turn on, and stay on until another two claps are detected.

$3.99
Ships Today
Microphone and Headphone...
Microphone and headphone splitter for 3.5mm headphone cables. Female 3.5mm jack to 2 Male stereo plugs for microphone and headphones.

$4.99
Ships Today
Selfie Light Ring with Lens -...
Selfie Ring Light that clips onto your cell phone to illuminate your selfies so you get great lighting in every shot! Built in Macro Lens for getting a wider angle shot on your selfies! Rechargeable via USB so you don't need batteries! Portable design great for travel, vlogging and on-the-go quality shots.

$16.90
Ships Today
USB Rechargeable AA Batteries &...
USB Powered AA battery charger + 4 rechargeable AA batteries. 4 NiMH 3000mah batteries and 2 battery USB charger.

$8.99
Ships Today
Nanny Cam Light Bulb Hidden...
View what is going on in your home / office with this hidden camera embedded within a light bulb. Supports memory cards up to 128GB. View the camera from an app on your smartphone from anywhere!

$34.99
Ships Today

Christmas Ornament DIY Soldering Kit Decoration Electronic LED Red Learn to Solder: Solder together your very own light up Christmas Ornament! Add some...
Read more
Running Microbug Kit Solder DIY Robot Bug Light Sensitive: Solder & assemble this Microbug robot and watch it drive towards...
Read more
SMD Star LED Soldering Kit SMT Christmas Decoration Electronic Ornament: Solder together your very own electronic star with 20 SMD LEDs! Slowly...
Read more

» All new products

⚡ Flash Sales ⚡

-55%
UV Curing Oven - 220V EU Plug
$44.99 $20.25

» All Flash Sales