Motor Driver 2A Dual L298 H-Bridge

Features:

• Chipset: L298N
• Dual H-Bridge Module

• Motor Power Supply Voltage: 5V-35V (Note: Motor Power pin is labelled 12V but can be anywhere in the given range)
• Maximum Motor Driving Current: 2A per bridge
• 5V Voltage Regulator on board so if your motor power supply voltage is 7V-35V, no additional logic power is required.
• Operating Voltage: 5V (for board logic)
• Operating Current: 36mA
  
• Max power: 25W
• Dimensions: 43 x 43 x 26mm
• Can control 2 bi-directional DC motors simultaneously or one Bi-Polar stepper motor (with 4 wires)
• Arduino & Raspberry Pi Compatible

Useful Reference: http://www.instructables.com/id/Arduino-Modules-L298N-Dual-H-Bridge-Motor-Controll/

Pinout:

• Out 1 & 2: Motor A (or Bi-polar stepper motor coil A)
• Out 3 & 4: Motor B (or Bi-polar stepper motor coil B)
• 12V: Motor Power (Can actually be from 5V-35V, just marked as 12V)
• GND: Ground
• 5V: 5v input (unnecessary if your power source is 7v-35v, if the power source is 7v-35v then it can act as a 5V 0.5A out)
• EnA: Enables PWM signal for Motor A
• In1: Enable Motor A
• In2: Enable Motor A
• In3: Enable Motor B
• In4: Enable Motor B
• EnB: Enables PWM signal for Motor B