APA102 LED Strip Controller (Dotstar Compatible)

Features:

• APA102 LED Strip Controller
• Voltage: 5V
• Works with:
• TS1386 High Speed Addressable RGB LED Strip 144 Pixel - 1m (Dotstar Compatible)
• Max Number of Pixels per Controller: 2450
• Number of pre-programmed modes: 125
• Adjustable speed
• Power-off Mode Save: will stay on the same mode even after powering off
• 5.5x2.1mm DC Jack for power
• Pinout: NOTE: THE COLORATION IS NOT STANDARD! PLEASE ENSURE YOU WIRE IT CORRECTLY DEPENDING ON YOUR STRIP'S PINOUT
• VCC: Black
• CLOCK: Green
• DATA: Red
• GND: Blue
• Includes:
• Controller
• Remote

Remote Control

Functions Of Each Button:

Testing and Matching:

Pressing and hold the AUTO button for up to 3 seconds until LED is out, 

release the AUTO button to go into the mode of switching in red,green,blue,yellow,purple,

cyan and white to test the your LED strip.

Pressing and hold the MATCH button for up to 3 seconds to match the Remote control with the receiving controller. 

Pressing and hold the MATCH button for up to 3 seconds to un-match.

Sections:

       Some of the patterns run in several sections, each section is the same. 

User can make the number of sections as follows: 5, 10, 15, 20, 25, 30,35. Pixel number of each section can be chosen as follows: 20, 30, 40, 50, 60, 70 .

Sum of pixels = Sections*Number per section

Receiving Controller：

Can be customized to support almost any kind of one-wire or two-wire controlled LED Strip.

User can short or break R5,R6,R7,R8 on the PCB to make the controller work with different LED Strip types: