High Density RGBW LED Strip - Addressable 1m (NeoPixel Compatible, Waterproof)

When you want to control each LED's color and intensity individually and A LOT of LEDs, this is your solution. Create cool lighting displays where each LED can be controlled all on it's own and turn on/off, change color and brightness by itself. Each LED contains both the RGB LED and an additional natural white LED inside! Use an Arduino board to control the strip using just 2 pins just like our LED Sequins and Addressable RGB LEDs. Each LED has a chip inside it to control it's behavior on it's own which allows you to cut the strip after any single LED if you want to use a shorter length!

  Specifications:

• LED Type: 5050 SMD Pixel (Individually Addressable Neopixel Compatible)
• Includes RGB + Natural White in each pixel
• Natural White (aka Neutral White) light is good for photography where color temperature is important
• Natural white color temperature: 4000-4500K
• Chipset: SK6812RGBW

• Size: Length 1 meters x Width 1.2cm x Thickness 0.5cm

• Emitting Color: RGBW (every LED can be a different color at the same time + an additional Natural White LED)

• IP67 Waterproof
• Grey Scale: 256
• 32 bit color (8 bit per channel)

• Working Voltage: 5V DC

• LED Quantity: 60 LEDs

• Max Wattage 18W/meter
• Max DC Current Draw: 3.6A/meter

• JST Connector Pinout:
  • VCC: Red Wire, 5V
  • GND: White Wire, 0V
  • DIN: Green Wire, Data In
  • DOUT: Data Out (Green wire, to next strip)
• Every LED is cuttable!

Use this power supply to power the whole strip.