Raspberry Pi Lipo Battery Power Hat with USB Hub

Technical Details

• Attach this Lipo Battery Power Hat on top or below your Raspberry Pi with the included standoffs
• Power Hat that does not take up the GPIO pins
• Easily power the Pi with Lipo batteries up to 3800mah
• Built in charger circuit & booster circuit
• Raspberry Pi form factor that stacks with standoffs to fit neatly above or below the board
• Allows you to power your Pi and one other USB item from a Lipo Battery as well as charge it.
• A power module especially designed for Raspberry Pi which mounts directly above it as a hat via standoffs while leaving the GPIO pins untouched
• Max Battery capacity: 3800mAH (Battery Not Included)
• Automatic recovery switch
• Built in USB Hub: Dual USB output
• Turn off the USB link, the power will automatically turn off within 30 seconds
• Can be used to power the Raspberry Pi as well as another USB device via the Hub such as a screen, an Android / iPhone / iPad or other electronic device that charges via standard USB port
• Max Output current: 1.8A
• Output voltage (no load): 5.1V ± 0.1V
• Standard charging current/voltage: 1.0A/5.0V
• Cut-off voltage for fully charging the Li-ion battery: 4.18V - 4.2V
• Double USB outputs, one for Raspberry Pi, the other for the embedded LCD screen
• Comes with fastening standoffs, screws and nuts, so you can stack the Raspberry Pi board with the module
• Fits all 3.7V Lipo Batteries with capacities up to 3200mah (you may have to change the plug on your lipo battery to fit the port on the expansion board, if so, this is the matching plug for crimping onto wires without soldering or for soldering there is a plug with long wires or a plug with short wires.)
• Micro USB Port onboard to charge the battery.
• Works with all Raspberry Pi Models

Includes:

1 x Raspberry Pi Lipo Battery Power Hat (lipo battery not included)
4 x Copper standoffs
4 x Screw
4 x Nut