E-ink / E-Paper Display for Raspberry Pi Zero images
E-ink / E-Paper Display for Raspberry Pi Zero
Price:
$29.99
e Ink / ePaper Display Raspberry Pi Zero Hat measuring 2.13 inches. Low power consumption and stays locked on the last loaded screen even when not powered!
Features:
- 2.1 inch eInk / ePaper Display for Raspberry Pi Zero & Raspberry Pi Zero W
- Can also be used with larger Raspberry Pi's with 40 pins including the Pi 3 B+
- Hat design: fits directly on top of the Raspberry Pi's 40 pin GPIO
- Resolution: 250x122
- Ultra low power consumption that stays locked on the last loaded screen (Power only used to refresh the image!)
- Wide viewing angle
- Looks great even in bright sunlight
- Preserved solder pads for SPI interface suitable for connecting with other controller boards like Arduino, STM32, etc.
- Communication Protocol: SPI (both 3 and 4 wire)
- Operating Voltage: 3.3V
- Outline dimension: 65mm × 30.2mm
- Display size: 23.71mm × 48.55mm
- Dot pitch: 0.194 × 0.194
- Grayscale: 2
- Full refresh time: 6s
- Refresh power: 26.4mW(typ.)
- Standby power: <0.017mW
- Viewing angle: >170°
| SYMBOL | DESCRIPTION |
|---|---|
| VCC | 3.3V |
| GND | Ground |
| NC | NC |
| DIN | SPI MOSI pin |
| CLK | SPI SCK pin |
| CS | SPI chip selection, low active |
| DC | Data/Command selection (high for data, low for command) |
| RST | External reset, low active |
| BUSY | Busy status output, low active |
-
Brand
-
ReferenceTS2902
-
In stock1 Item
